Check the inputs before trusting the total.

These tools apply the formula displayed on each calculator page to the values you enter. A mathematically consistent result can still be unsuitable when its specification, units or cost boundary are wrong.

単位と次元の確認

Convert lengths to consistent units before finding area. Multiply area in m² by GSM in g/m² and divide by 1,000 to obtain kilograms. For a uniform material, thickness in µm multiplied by density in g/cm³ gives estimated GSM. Multilayer structures require layer contributions and retained additions.

定義と SI 接頭語の参考資料:BIPM — The International System of Units、NIST — SI 単位。これらは単位体系の根拠であり、Nalyquo の推薦、ソフトウェアの検証、特定樹脂の密度認証を行うものではありません。

根拠のある入力を優先

  • Use supplier-measured complete GSM rather than estimating from a generic density where available.
  • Use net material mass when converting material prices; keep core and shipment tare separate.
  • Use the approved blank or web layout instead of guessing from finished package dimensions.
  • Record whether freight, tooling and components are included before adding them.

材料の既定密度

The following values are editable planning assumptions used by the current tools. They are not grade-specific measurements and currently have no linked supplier certificate. Replace them with the actual technical data sheet or measured value. A material name does not establish composition or performance.

Default planning densities in g/cm³
材料既定値
LDPE0.92
LLDPE0.92
MDPE0.935
HDPE0.95
PE(一般)0.92
PP0.905
BOPP0.905
CPP0.905
PET / BOPET1.39
PA6/ナイロン1.14
EVOH1.19
アルミ箔2.7

ロスと丸め

Where waste is defined on gross input, gross requirement = net requirement ÷ (1 − loss fraction). For 1,000 kg of good output with 5% gross-input loss, this is 1,052.6316 kg. Adding 5% to net demand is a different convention. Preserve intermediate precision; round indivisible items or purchase quantities up as required by the actual order.

検証とその限界

Before recent releases, the application build, TypeScript checks and internal-link checks were run. These checks establish software and page consistency, not independent engineering approval. Visible worked examples allow arithmetic to be reproduced; they are not supplier quotations or field-test results. We do not claim every possible input combination has been independently validated.

重要な購入では、承認済み仕様で別途計算し、結果を再現してください。結果が異なる場合に記録すべき内容は、訂正方針をご覧ください。

最初の公開記録: · 更新: · 確認:

ページの完全性、リンク、計算例の自動確認です。独立した専門家による審査を主張するものではありません。