Build laminate basis weight from mil layers and dry additions

For each homogeneous layer, multiply thickness in mils by 25.4 and its stated density in g/cm³. Add separately confirmed dry adhesive, ink and coating GSM.

نشر بواسطة Nalyquo · ·

حسابات توضيحية؛ لا يُدعى وجود مراجعة مختص مستقل. يضيف هذا التحديث معلومات النشر والمنهجية.

المنهج ونطاق المراجعالسياسة التحريرية والتصحيحات

Set up the US purchasing comparison

For each homogeneous layer, multiply thickness in mils by 25.4 and its stated density in g/cm³. Add separately confirmed dry adhesive, ink and coating GSM.

Formula and worked US example

Total GSM = Σ(Mil thickness × 25.4 × Density(g/cm³)) + Dry additions

A 0.5-mil layer at 1.39 g/cm³ contributes 17.653 GSM. A 2-mil layer at 0.92 g/cm³ contributes 46.736 GSM. Adding 2 dry GSM of adhesive gives 66.389 GSM total and about 73.54 ft²/lb of coverage yield.

Checks before using the estimate

Prefer representative measured complete-laminate GSM when available. Wet adhesive delivery mass is not retained dry coating mass.

  • Use actual supplier prices in place of these independent illustrative dollar quotes. No exchange rate is implied.
  • Keep the same technical specification, accepted-output denominator and delivery boundary across alternatives.

أسئلة شائعة

Can I reproduce the US figures in a calculator?

Open a related US calculator below and enter the stated quantities with their matching unit prices. Intermediate values in this article may be rounded.

What should I verify before using this result?

Prefer representative measured complete-laminate GSM when available. Wet adhesive delivery mass is not retained dry coating mass.