HERRAMIENTA 51 / 136

Adhesive Consumption Calculator — US Units

Adhesive Consumption connects the figures on a US supplier quote with the quantity used by your packaging operation. Have film area (ft²), dry adhesive coat weight (g/m²), adhesive solids (%) ready before you start.

Tus especificaciones

g/m²
%
Los resultados se actualizan al editar. No se guarda nada hasta que tú lo decidas.
Cálculo en tiempo real

Adhesivo húmedo necesario

11,02 lb
Adhesivo seco retenido4,41 lb
Gramaje de aplicación húmeda5,00 g/m²

Los sólidos se expresan en masa. Es un consumo teórico antes de pérdidas de recubrimiento, mezcla o limpieza.

Dry lb = Area(ft²) × Dry GSM × 0.0002048161436; Wet lb = Dry lb ÷ Solids fraction

Film area: 10763.910416709721 ft²; Dry adhesive coat weight: 2 g/m²; Adhesive solids: 40 % → 11,02 lb

Calculado con tus datos. Confirma las especificaciones con tu proveedor.

La fórmula, explicada.

Dry lb = Area(ft²) × Dry GSM × 0.0002048161436; Wet lb = Dry lb ÷ Solids fraction

The result answers a specific purchasing question: Work out adhesive consumption with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read wet adhesive required in lb. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.

Cómo usar esta calculadora

  1. 01

    Collect Film area (ft²); Dry adhesive coat weight (g/m²); Adhesive solids (%). Leave optional unknown values blank rather than substituting zero.

  2. 02

    Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.

  3. 03

    Review wet adhesive required and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.

Un cálculo que puedes comprobar

For this US purchasing example, enter film area 10,763.91 ft², dry adhesive coat weight 2.00 g/m², adhesive solids 40.00 %. The calculated wet adhesive required is 11.02 lb. The table lists the remaining inputs and results so the scenario can be checked or reproduced.

Superficie de film
10.763,9104 ft²
Gramaje seco del adhesivo
2 g/m²
Sólidos del adhesivo
40 %
Dry lb = Area(ft²) × Dry GSM × 0.0002048161436; Wet lb = Dry lb ÷ Solids fraction
Adhesivo húmedo necesario11,02 lb

Preguntas frecuentes

Which units should I use for adhesive consumption?

Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.

Can I compare two adhesive consumption results directly?

Yes, when both runs use the same specification, purchasing boundary and included charges. Record film area (ft²), dry adhesive coat weight (g/m²), adhesive solids (%) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.

Comprueba la fórmula, las unidades y los supuestos mostrados antes de utilizar el resultado.

Método, unidades y supuestos del material ↗