Thermoformed Part Material Weight Calculator — US Units
Thermoformed Part Material Weight connects the figures on a US supplier quote with the quantity used by your packaging operation. Have web width (inch), machine pitch (inch), parts across (units) ready before you start.
Tus especificaciones
Material bruto de hoja asignado por pieza
Es una asignación bruta de banda, no el peso de la pieza terminada. La diferencia incluye la retícula sobrante y todo material fuera de la pieza retenida.
Supone una fila de piezas en dirección de máquina por paso introducido; incluya todas las cavidades a lo ancho de esa repetición.
Gross lb/part = Web width(in) × Pitch(in) ÷ (144 × Parts across) × Sheet GSM × 0.0002048161436
Web width: 31.496062992125985 inch; Machine pitch: 11.811023622047244 inch; Parts across: 4 units; Sheet GSM: 600 g/m² → 0,0794 lb/partCalculado con tus datos. Confirma las especificaciones con tu proveedor.
La fórmula, explicada.
The result answers a specific purchasing question: Work out thermoformed part material weight with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read gross sheet material allocation per part in lb/part. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
Cómo usar esta calculadora
- 01
Collect Web width (inch); Machine pitch (inch); Parts across (units); Sheet GSM (g/m²). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review gross sheet material allocation per part and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
Un cálculo que puedes comprobar
For this US purchasing example, enter web width 31.50 inch, machine pitch 11.81 inch, parts across 4.00 units, sheet gsm 600.00 g/m². The calculated gross sheet material allocation per part is 0.0794 lb/part. The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- Ancho de banda
- 31,496063 inch
- Paso de máquina
- 11,8110236 inch
- Piezas a lo ancho
- 4 unidades
- Gramaje de lámina
- 600 g/m²
Gross lb/part = Web width(in) × Pitch(in) ÷ (144 × Parts across) × Sheet GSM × 0.0002048161436Preguntas frecuentes
Which units should I use for thermoformed part material weight?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two thermoformed part material weight results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record web width (inch), machine pitch (inch), parts across (units), sheet gsm (g/m²) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
Comprueba la fórmula, las unidades y los supuestos mostrados antes de utilizar el resultado.
Método, unidades y supuestos del material ↗