Carton Tooling Amortization Calculator — US Units
Carton Tooling Amortization connects the figures on a US supplier quote with the quantity used by your packaging operation. Have cutting die (currency), printing plates (currency), foil tooling (currency) ready before you start.
Vos spécifications
Libellé d’unité uniquement. Aucune conversion de devise.
Coût par carton
Suppose la production de la quantité saisie sur la durée de vie. L’outillage de remplacement ultérieur n’est pas inclus.
Outillage/unité = (Découpe + Plaques + Outil de dorure + Outil de gaufrage + Autre calage) ÷ Quantité d’allocation
Cutting die: 1200 USD; Printing plates: 600 USD; Foil tooling: 0 USD; Embossing tooling: 0 USD; Other setup: 0 USD; Expected lifetime cartons: 1000000 units → US$0,00180/cartonCalculé à partir de vos données. Confirmez les spécifications avec votre fournisseur.
La formule expliquée.
The result answers a specific purchasing question: Work out carton tooling amortization with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read cost per carton in your selected currency/carton. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
Comment utiliser ce calculateur
- 01
Collect Cutting die (currency); Printing plates (currency); Foil tooling (currency); Embossing tooling (currency); Other setup (currency); Expected lifetime cartons (units). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review cost per carton and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
Un calcul que vous pouvez vérifier
For this US purchasing example, enter cutting die US$1,200.00, printing plates US$600.00, foil tooling US$0.00000, embossing tooling US$0.00000. The calculated cost per carton is US$0.00180/carton. The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- Forme de découpe
- 1 200 USD
- Plaques d’impression
- 600 USD
- Outillage de dorure
- 0 USD
- Outillage de gaufrage
- 0 USD
- Autre réglage
- 0 USD
- Étuis prévus sur la durée de vie
- 1 000 000 unités
Tooling/unit = (Die + Plates + Foil tooling + Embossing tooling + Other setup) ÷ Allocation quantityQuestions fréquentes
Which units should I use for carton tooling amortization?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two carton tooling amortization results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record cutting die (currency), printing plates (currency), foil tooling (currency), embossing tooling (currency) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
Vérifiez la formule, les unités et les hypothèses affichées avant d’utiliser le résultat.
Méthode, unités et hypothèses sur les matériaux ↗