OUTIL 07 / 136

Roll Price to Price per ft² Calculator — US Units

Roll Price to Price per ft² connects the figures on a US supplier quote with the quantity used by your packaging operation. Have price per roll (currency), web width (inch), roll length (ft) ready before you start.

Vos spécifications

USD

Indication de devise uniquement. Aucune conversion.

Les résultats s’actualisent pendant la saisie. Rien n’est enregistré sans votre choix.
Calcul en direct

Price per ft²

US$0,02787/ft²
Surface du film de la bobine8 611,13 ft²

Area(ft²) = Width(in) ÷ 12 × Length(ft); Price/ft² = Roll price ÷ Area(ft²)

Price per roll: 240 USD; Web width: 31.496062992125985 inch; Roll length: 3280.839895013123 ft → US$0,02787/ft²

Calculé à partir de vos données. Confirmez les spécifications avec votre fournisseur.

La formule expliquée.

Area(ft²) = Width(in) ÷ 12 × Length(ft); Price/ft² = Roll price ÷ Area(ft²)

The result answers a specific purchasing question: Work out roll price to price per ft² with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read price per ft² in your selected currency/ft². Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.

Comment utiliser ce calculateur

  1. 01

    Collect Price per roll (currency); Web width (inch); Roll length (ft). Leave optional unknown values blank rather than substituting zero.

  2. 02

    Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.

  3. 03

    Review price per ft² and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.

Un calcul que vous pouvez vérifier

For this US purchasing example, enter price per roll US$240.00, web width 31.50 inch, roll length 3,280.84 ft. The calculated price per ft² is US$0.02787/ft². The table lists the remaining inputs and results so the scenario can be checked or reproduced.

Prix par bobine
240 USD
Largeur de bande
31,496063 inch
Longueur de bobine
3 280,8399 ft
Area(ft²) = Width(in) ÷ 12 × Length(ft); Price/ft² = Roll price ÷ Area(ft²)
Price per ft²US$0,02787/ft²

Questions fréquentes

Which units should I use for roll price to price per ft²?

Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.

Can I compare two roll price to price per ft² results directly?

Yes, when both runs use the same specification, purchasing boundary and included charges. Record price per roll (currency), web width (inch), roll length (ft) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.

Vérifiez la formule, les unités et les hypothèses affichées avant d’utiliser le résultat.

Méthode, unités et hypothèses sur les matériaux ↗