Packaging Reorder Point Calculator — US Units
Packaging Reorder Point connects the figures on a US supplier quote with the quantity used by your packaging operation. Have average usage per day (units/day), supplier lead time (days), chosen safety stock (units) ready before you start.
사양 입력
재주문 재고 수준
일일 사용량과 납기는 가동일 또는 달력일 중 같은 기준을 사용해야 합니다.
안전 재고는 입력값이며 서비스 수준이나 수요 분포에서 추정하지 않습니다.
주문량, EOQ, 공급업체 신뢰도 또는 보장된 재고 부족 확률은 계산하지 않습니다.
재주문점 = ceil(일일 사용량 × 납기 + 안전 재고)
Average usage per day: 1000 units/day; Supplier lead time: 15 days; Chosen safety stock: 5000 units → 20,000.00 개입력한 값으로 계산했습니다. 공급업체에 사양을 확인하세요.
계산식을 알기 쉽게.
The result answers a specific purchasing question: Work out packaging reorder point with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read reorder inventory position in units. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
계산기 사용 방법
- 01
Collect Average usage per day (units/day); Supplier lead time (days); Chosen safety stock (units). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review reorder inventory position and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
검증할 수 있는 계산
For this US purchasing example, enter average usage per day 1,000.00 units/day, supplier lead time 15.00 days, chosen safety stock 5,000.00 units. The calculated reorder inventory position is 20,000.00 units. The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- 일평균 사용량
- 1,000 개/day
- 공급업체 납기
- 15 일
- 선택한 안전 재고
- 5,000 개
Reorder point = ceil(Daily usage × Lead time + Safety stock)자주 묻는 질문
Which units should I use for packaging reorder point?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two packaging reorder point results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record average usage per day (units/day), supplier lead time (days), chosen safety stock (units) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
결과를 사용하기 전에 표시된 공식, 단위 및 가정을 확인하세요.
계산 방법, 단위 및 재료 가정 ↗