Supplier Switch Break-Even Quantity Calculator — US Units
Supplier Switch Break-Even Quantity connects the figures on a US supplier quote with the quantity used by your packaging operation. Have current comparable unit cost (currency), new comparable unit cost (currency), one-time switching cost (currency) ready before you start.
Ваши параметры
Только обозначение валюты. Курс не пересчитывается.
Количество единиц для окупаемости перехода
Новая текущая стоимость единицы должна быть ниже действующей.
Финансирование, дисконтирование, риск качества и списание запасов не учитываются, если они явно не включены в затраты на переход.
Оба предложения должны использовать одну валюту и одинаковый коммерческий состав.
Объём окупаемости = ceil(Разовые расходы перехода ÷ (Текущая стоимость единицы − Новая стоимость единицы))
Current comparable unit cost: 0.25 USD; New comparable unit cost: 0.22 USD; One-time switching cost: 1500 USD → 50 000,00 шт.Рассчитано по вашим данным. Подтвердите параметры у поставщика.
Понятное объяснение формулы.
The result answers a specific purchasing question: Work out supplier switch break-even quantity with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read units to recover switching cost in units. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
Как пользоваться калькулятором
- 01
Collect Current comparable unit cost (currency); New comparable unit cost (currency); One-time switching cost (currency). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review units to recover switching cost and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
Расчёт, который можно проверить
For this US purchasing example, enter current comparable unit cost US$0.2500, new comparable unit cost US$0.2200, one-time switching cost US$1,500.00. The calculated units to recover switching cost is 50,000.00 units. The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- Текущая сопоставимая стоимость единицы
- 0,25 USD
- Новая сопоставимая стоимость единицы
- 0,22 USD
- Разовые затраты на переход
- 1 500 USD
Break-even units = ceil(One-time switching cost ÷ (Current unit cost − New unit cost))Частые вопросы
Which units should I use for supplier switch break-even quantity?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two supplier switch break-even quantity results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record current comparable unit cost (currency), new comparable unit cost (currency), one-time switching cost (currency) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
Перед использованием результата проверьте показанную формулу, единицы измерения и допущения.
Методика, единицы и допущения о материале ↗