ツール 114 / 136

Nested Tray Stack Height Calculator — US Units

Nested Tray Stack Height connects the figures on a US supplier quote with the quantity used by your packaging operation. Have first tray height (inch), additional nesting pitch (inch), trays in stack (units) ready before you start.

仕様を入力

個
入力を変更すると結果も更新されます。保存を選ぶまでデータは保存されません。
リアルタイム計算

推定ネスティング高さ

33.15 inch
Stack height in feet2.76 ft

入力した追加ネスティングピッチを使用します。実際の圧縮、部品公差、重なり方は異なる場合があります。安全積載荷重の計算ではありません。

積み重ね高さ = 最初の1個の高さ +(数量 − 1)× ネスティングピッチ

First tray height: 1.968503937007874 inch; Additional nesting pitch: 0.31496062992125984 inch; Trays in stack: 100 units → 33.15 inch

入力値に基づく計算です。仕様は仕入先に確認してください。

計算式をわかりやすく。

積み重ね高さ = 最初の1個の高さ +(数量 − 1)× ネスティングピッチ

The result answers a specific purchasing question: Work out nested tray stack height with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read estimated nested stack height in inch. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.

この計算ツールの使い方

  1. 01

    Collect First tray height (inch); Additional nesting pitch (inch); Trays in stack (units). Leave optional unknown values blank rather than substituting zero.

  2. 02

    Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.

  3. 03

    Review estimated nested stack height and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.

検算できる計算例

For this US purchasing example, enter first tray height 1.97 inch, additional nesting pitch 0.3150 inch, trays in stack 100.00 units. The calculated estimated nested stack height is 33.15 inch. The table lists the remaining inputs and results so the scenario can be checked or reproduced.

最初のトレーの高さ
1.96850394 inch
追加の入れ子ピッチ
0.31496063 inch
積み重ねたトレー数
100 個
Stack height = First item height + (Quantity − 1) × Nesting pitch
推定ネスティング高さ33.15 inch

よくある質問

Which units should I use for nested tray stack height?

Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.

Can I compare two nested tray stack height results directly?

Yes, when both runs use the same specification, purchasing boundary and included charges. Record first tray height (inch), additional nesting pitch (inch), trays in stack (units) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.

結果を使用する前に、表示された式、単位、前提条件を確認してください。

計算方法・単位・材料の前提条件 ↗