Roll Area Calculator — US Units
Roll Area connects the figures on a US supplier quote with the quantity used by your packaging operation. Have web width (inch), roll length (ft), film gsm (g/m²) ready before you start.
仕様を入力
仕入先の実際の坪量または実測値がある場合は、それを使用してください。
ロールのフィルム面積
Area(ft²) = Width(in) ÷ 12 × Length(ft)
Web width: 31.496062992125985 inch; Roll length: 3280.839895013123 ft; Film GSM: 80 g/m² → 8,611.13 ft²入力値に基づく計算です。仕様は仕入先に確認してください。
計算式をわかりやすく。
The result answers a specific purchasing question: Work out roll area with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read roll film area in ft². Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
この計算ツールの使い方
- 01
Collect Web width (inch); Roll length (ft); Film GSM (g/m²). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review roll film area and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
検算できる計算例
For this US purchasing example, enter web width 31.50 inch, roll length 3,280.84 ft, film gsm 80.00 g/m². The calculated roll film area is 8,611.13 ft². The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- ウェブ幅
- 31.496063 inch
- ロール長さ
- 3,280.8399 ft
- フィルム坪量
- 80 g/m²
Area(ft²) = Width(in) ÷ 12 × Length(ft)よくある質問
Which units should I use for roll area?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two roll area results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record web width (inch), roll length (ft), film gsm (g/m²) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
結果を使用する前に、表示された式、単位、前提条件を確認してください。
計算方法・単位・材料の前提条件 ↗