FERRAMENTA 33 / 136

Roll Weight from Length Calculator — US Units

Roll Weight from Length connects the figures on a US supplier quote with the quantity used by your packaging operation. Have roll length (ft), web width (inch), film gsm (g/m²) ready before you start.

As suas especificações

g/m²

Utilize a gramagem real do fornecedor ou medida, quando disponível.

Os resultados atualizam-se ao editar. Nada é guardado até decidir fazê-lo.
Cálculo em tempo real

Massa líquida do filme no rolo

141,10 lb
Área do filme8.611,13 ft²

Exclui o núcleo e toda a embalagem exterior.

Net roll lb = Length(ft) × Width(in) ÷ 12 × GSM × 0.0002048161436

Roll length: 3280.839895013123 ft; Web width: 31.496062992125985 inch; Film GSM: 80 g/m² → 141,10 lb

Calculado a partir dos seus dados. Confirme as especificações com o fornecedor.

A fórmula explicada.

Net roll lb = Length(ft) × Width(in) ÷ 12 × GSM × 0.0002048161436

The result answers a specific purchasing question: Work out roll weight from length with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read net roll film weight in lb. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.

Como utilizar esta calculadora

  1. 01

    Collect Roll length (ft); Web width (inch); Film GSM (g/m²). Leave optional unknown values blank rather than substituting zero.

  2. 02

    Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.

  3. 03

    Review net roll film weight and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.

Um cálculo que pode verificar

For this US purchasing example, enter roll length 3,280.84 ft, web width 31.50 inch, film gsm 80.00 g/m². The calculated net roll film weight is 141.10 lb. The table lists the remaining inputs and results so the scenario can be checked or reproduced.

Comprimento do rolo
3.280,8399 ft
Largura da banda
31,496063 inch
Gramagem do filme
80 g/m²
Net roll lb = Length(ft) × Width(in) ÷ 12 × GSM × 0.0002048161436
Massa líquida do filme no rolo141,10 lb

Perguntas frequentes

Which units should I use for roll weight from length?

Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.

Can I compare two roll weight from length results directly?

Yes, when both runs use the same specification, purchasing boundary and included charges. Record roll length (ft), web width (inch), film gsm (g/m²) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.

Verifique a fórmula, as unidades e os pressupostos apresentados antes de utilizar o resultado.

Método, unidades e pressupostos dos materiais ↗