Build laminate basis weight from mil layers and dry additions

For each homogeneous layer, multiply thickness in mils by 25.4 and its stated density in g/cm³. Add separately confirmed dry adhesive, ink and coating GSM.

Издатель: Nalyquo · ·

Иллюстративные расчёты; независимая экспертная проверка не заявляется. Обновление добавляет сведения о публикации и методике.

Методика и границы источниковРедакционная политика и исправления

Set up the US purchasing comparison

For each homogeneous layer, multiply thickness in mils by 25.4 and its stated density in g/cm³. Add separately confirmed dry adhesive, ink and coating GSM.

Formula and worked US example

Total GSM = Σ(Mil thickness × 25.4 × Density(g/cm³)) + Dry additions

A 0.5-mil layer at 1.39 g/cm³ contributes 17.653 GSM. A 2-mil layer at 0.92 g/cm³ contributes 46.736 GSM. Adding 2 dry GSM of adhesive gives 66.389 GSM total and about 73.54 ft²/lb of coverage yield.

Checks before using the estimate

Prefer representative measured complete-laminate GSM when available. Wet adhesive delivery mass is not retained dry coating mass.

  • Use actual supplier prices in place of these independent illustrative dollar quotes. No exchange rate is implied.
  • Keep the same technical specification, accepted-output denominator and delivery boundary across alternatives.

Частые вопросы

Can I reproduce the US figures in a calculator?

Open a related US calculator below and enter the stated quantities with their matching unit prices. Intermediate values in this article may be rounded.

What should I verify before using this result?

Prefer representative measured complete-laminate GSM when available. Wet adhesive delivery mass is not retained dry coating mass.