Cartons per Sheet Calculator — US Units
Cartons per Sheet connects the figures on a US supplier quote with the quantity used by your packaging operation. Have sheet width (inch), sheet length (inch), actual blank width (inch) ready before you start.
您的规格参数
最佳简单矩形排版
仅比较两种统一矩形方向。不含间隔、叼口边、纸纹方向限制及不规则刀模套排。
每张纸盒数 = 向下取整(纸张宽度 ÷ 坯料宽度)× 向下取整(纸张长度 ÷ 坯料长度)
Sheet width: 47.24409448818898 inch; Sheet length: 31.496062992125985 inch; Actual blank width: 19.68503937007874 inch; Actual blank length: 15.748031496062993 inch → 4.00 blanks/sheet根据您输入的数据计算。请与供应商确认规格。
公式解释。
The result answers a specific purchasing question: Work out cartons per sheet with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read best simple rectangular layout in blanks/sheet. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
如何使用此计算器
- 01
Collect Sheet width (inch); Sheet length (inch); Actual blank width (inch); Actual blank length (inch). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review best simple rectangular layout and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
可以核验的计算
For this US purchasing example, enter sheet width 47.24 inch, sheet length 31.50 inch, actual blank width 19.69 inch, actual blank length 15.75 inch. The calculated best simple rectangular layout is 4.00 blanks/sheet. The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- 纸板宽度
- 47.2440945 inch
- 纸板长度
- 31.496063 inch
- 实际坯料宽度
- 19.6850394 inch
- 实际坯料长度
- 15.7480315 inch
Cartons/sheet = floor(Sheet width ÷ Blank width) × floor(Sheet length ÷ Blank length)常见问题
Which units should I use for cartons per sheet?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two cartons per sheet results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record sheet width (inch), sheet length (inch), actual blank width (inch), actual blank length (inch) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
使用结果前,请核对显示的公式、单位和假设。
方法、单位和材料假设 ↗