Molded Fiber Tooling Amortization Calculator — US Units
Molded Fiber Tooling Amortization connects the figures on a US supplier quote with the quantity used by your packaging operation. Have mold / die cost (currency), initial setup cost (currency), expected lifetime items (units) ready before you start.
您的规格参数
仅为单位标识,不进行货币换算。
每件成本
使用寿命产量是规划假设。除非已包含在输入金额中,否则不含替换模具和再次调机。
如果托盘报价已包含模具费,请勿再次加入此分摊费用。
单件模具费 =(成型模具或刀模费 + 初始准备费)÷ 预计寿命件数;每千件模具费 = 单件模具费 × 1,000
Mold / die cost: 1500 USD; Initial setup cost: 500 USD; Expected lifetime items: 100000 units → US$0.02000/件根据您输入的数据计算。请与供应商确认规格。
公式解释。
The result answers a specific purchasing question: Work out molded fiber tooling amortization with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read cost per item in your selected currency/item. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
如何使用此计算器
- 01
Collect Mold / die cost (currency); Initial setup cost (currency); Expected lifetime items (units). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review cost per item and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
可以核验的计算
For this US purchasing example, enter mold / die cost US$1,500.00, initial setup cost US$500.00, expected lifetime items 100,000.00 units. The calculated cost per item is US$0.02000/item. The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- 模具/冲模成本
- 1,500 USD
- 首次设定费用
- 500 USD
- 寿命期预计件数
- 100,000 件
Tooling cost/item = (Mold or die cost + Initial setup) ÷ Expected lifetime items; Tooling cost/1,000 = Tooling cost/item × 1,000常见问题
Which units should I use for molded fiber tooling amortization?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two molded fiber tooling amortization results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record mold / die cost (currency), initial setup cost (currency), expected lifetime items (units) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
使用结果前,请核对显示的公式、单位和假设。
方法、单位和材料假设 ↗