工具 136 / 136

Packaging Reorder Point Calculator — US Units

Packaging Reorder Point connects the figures on a US supplier quote with the quantity used by your packaging operation. Have average usage per day (units/day), supplier lead time (days), chosen safety stock (units) ready before you start.

您的规格参数

units/day
天
件
修改参数时结果会自动更新。仅在您选择保存时才会保存。
实时计算

再订货库存水平

20,000.00 件
交货周期内预计需求15,000.00 件

日用量和交货周期必须统一采用工作日或自然日基准。

安全库存需输入,不根据服务水平或需求分布推算。

不计算订购数量、经济订货量、供应商可靠性或有保证的缺货概率。

再订货点 = ceil(日用量 × 交期 + 安全库存)

Average usage per day: 1000 units/day; Supplier lead time: 15 days; Chosen safety stock: 5000 units → 20,000.00 件

根据您输入的数据计算。请与供应商确认规格。

公式解释。

再订货点 = ceil(日用量 × 交期 + 安全库存)

The result answers a specific purchasing question: Work out packaging reorder point with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read reorder inventory position in units. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.

如何使用此计算器

  1. 01

    Collect Average usage per day (units/day); Supplier lead time (days); Chosen safety stock (units). Leave optional unknown values blank rather than substituting zero.

  2. 02

    Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.

  3. 03

    Review reorder inventory position and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.

可以核验的计算

For this US purchasing example, enter average usage per day 1,000.00 units/day, supplier lead time 15.00 days, chosen safety stock 5,000.00 units. The calculated reorder inventory position is 20,000.00 units. The table lists the remaining inputs and results so the scenario can be checked or reproduced.

日均用量
1,000 件/day
供应商交货周期
15 天
选定安全库存
5,000 件
Reorder point = ceil(Daily usage × Lead time + Safety stock)
再订货库存水平20,000.00 件

常见问题

Which units should I use for packaging reorder point?

Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.

Can I compare two packaging reorder point results directly?

Yes, when both runs use the same specification, purchasing boundary and included charges. Record average usage per day (units/day), supplier lead time (days), chosen safety stock (units) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.

使用结果前,请核对显示的公式、单位和假设。

方法、单位和材料假设 ↗