HERRAMIENTA 19 / 136

mils to GSM Calculator — US Units

mils to GSM connects the figures on a US supplier quote with the quantity used by your packaging operation. Have film thickness (mil), material density (g/cm³) ready before you start.

Tus especificaciones

g/cm³

Densidad típica. La densidad real varía según el grado y la formulación de la resina; utilice datos del proveedor o medidos cuando estén disponibles.

Los resultados se actualizan al editar. No se guarda nada hasta que tú lo decidas.
Cálculo en tiempo real

Gramaje estimado de la película

16,68 g/m²
Rendimiento estimado de la película292,71 ft²/lb

Estimated using typical PET / BOPET density of 1.39 g/cm³. Actual density varies by resin grade and formulation.

En un laminado, calcule cada capa de material por separado. No use una densidad genérica para el papel.

GSM = Thickness(mil) × 25.4 × Density(g/cm³)

Film thickness: 0.47244094488188976 mil; Material density: 1.39 g/cm³ → 16,68 g/m²

Calculado con tus datos. Confirma las especificaciones con tu proveedor.

La fórmula, explicada.

GSM = Thickness(mil) × 25.4 × Density(g/cm³)

The result answers a specific purchasing question: Work out mils to gsm with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read estimated film gsm in g/m². Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.

Cómo usar esta calculadora

  1. 01

    Collect Film thickness (mil); Material density (g/cm³). Leave optional unknown values blank rather than substituting zero.

  2. 02

    Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.

  3. 03

    Review estimated film gsm and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.

Un cálculo que puedes comprobar

For this US purchasing example, enter film thickness 0.4724 mil, material density 1.39 g/cm³. The calculated estimated film gsm is 16.68 g/m². The table lists the remaining inputs and results so the scenario can be checked or reproduced.

Espesor del film
0,472440945 mil
Densidad del material
1,39 g/cm³
GSM = Thickness(mil) × 25.4 × Density(g/cm³)
Gramaje estimado de la película16,68 g/m²

Preguntas frecuentes

Which units should I use for mils to gsm?

Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.

Can I compare two mils to gsm results directly?

Yes, when both runs use the same specification, purchasing boundary and included charges. Record film thickness (mil), material density (g/cm³) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.

Comprueba la fórmula, las unidades y los supuestos mostrados antes de utilizar el resultado.

Método, unidades y supuestos del material ↗