Closure Order with Rejection Allowance Calculator — US Units
Closure Order with Rejection Allowance connects the figures on a US supplier quote with the quantity used by your packaging operation. Have good closures required (units), expected closure rejection (%), closures per supplier carton (units) ready before you start.
仕様を入力
購入キャップ数
完成品1個にキャップ1個が必要です。
不良率は購入キャップ総数に適用し、交換は想定しません。
別の最小発注量や生産立上げの余裕は含みません。
箱数 = ceil(良品目標数 ÷ (1 − 不良率/100) ÷ 箱当たり数量)
Good closures required: 50000 units; Expected closure rejection: 1 %; Closures per supplier carton: 2000 units → 52,000.00 個入力値に基づく計算です。仕様は仕入先に確認してください。
計算式をわかりやすく。
The result answers a specific purchasing question: Work out closure order with rejection allowance with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read closures to purchase in units. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
この計算ツールの使い方
- 01
Collect Good closures required (units); Expected closure rejection (%); Closures per supplier carton (units). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review closures to purchase and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
検算できる計算例
For this US purchasing example, enter good closures required 50,000.00 units, expected closure rejection 1.00 %, closures per supplier carton 2,000.00 units. The calculated closures to purchase is 52,000.00 units. The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- 必要な良品キャップ数
- 50,000 個
- 想定キャップ不良率
- 1 %
- 仕入先カートン1箱当たりのキャップ数
- 2,000 個
Cartons = ceil(Good target ÷ (1 − Rejection/100) ÷ Carton quantity)よくある質問
Which units should I use for closure order with rejection allowance?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two closure order with rejection allowance results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record good closures required (units), expected closure rejection (%), closures per supplier carton (units) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
結果を使用する前に、表示された式、単位、前提条件を確認してください。
計算方法・単位・材料の前提条件 ↗