ツール 83 / 136

Label Roll Length from Count Calculator — US Units

Label Roll Length from Count connects the figures on a US supplier quote with the quantity used by your packaging operation. Have required label count (units), label pitch including gap (inch), labels across (units) ready before you start.

仕様を入力

個
個
入力を変更すると結果も更新されます。保存を選ぶまでデータは保存されません。
リアルタイム計算

完全な列に必要な最短ウェブ長

3,280.84 ft
必要な完全列数10,000.00 rows
最終列の余剰ラベル数0.00 labels

完全な列数に切り上げます。先端、末端、継ぎ代、工程ロスは別途加算してください。

Required rows = ceil(Label count ÷ Labels across); Length(ft) = Rows × Pitch(in) ÷ 12

Required label count: 10000 units; Label pitch including gap: 3.937007874015748 inch; Labels across: 1 units → 3,280.84 ft

入力値に基づく計算です。仕様は仕入先に確認してください。

計算式をわかりやすく。

Required rows = ceil(Label count ÷ Labels across); Length(ft) = Rows × Pitch(in) ÷ 12

The result answers a specific purchasing question: Work out label roll length from count with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read minimum complete-row web length in ft. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.

この計算ツールの使い方

  1. 01

    Collect Required label count (units); Label pitch including gap (inch); Labels across (units). Leave optional unknown values blank rather than substituting zero.

  2. 02

    Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.

  3. 03

    Review minimum complete-row web length and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.

検算できる計算例

For this US purchasing example, enter required label count 10,000.00 units, label pitch including gap 3.94 inch, labels across 1.00 units. The calculated minimum complete-row web length is 3,280.84 ft. The table lists the remaining inputs and results so the scenario can be checked or reproduced.

必要ラベル数
10,000 個
隙間込みのラベルピッチ
3.93700787 inch
幅方向のラベル列数
1 個
Required rows = ceil(Label count ÷ Labels across); Length(ft) = Rows × Pitch(in) ÷ 12
完全な列に必要な最短ウェブ長3,280.84 ft

よくある質問

Which units should I use for label roll length from count?

Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.

Can I compare two label roll length from count results directly?

Yes, when both runs use the same specification, purchasing boundary and included charges. Record required label count (units), label pitch including gap (inch), labels across (units) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.

結果を使用する前に、表示された式、単位、前提条件を確認してください。

計算方法・単位・材料の前提条件 ↗