Labels per Roll Calculator — US Units
Labels per Roll connects the figures on a US supplier quote with the quantity used by your packaging operation. Have usable roll length (ft), label pitch including gap (inch), labels across (units) ready before you start.
仕様を入力
1ロール当たりの完全なラベル数
先端・末端を除いた有効ロール長を使用してください。ピッチはラベルと機械方向の隙間を含みます。
Labels = floor(Usable length(ft) × 12 ÷ Label pitch(in)) × Labels across
Usable roll length: 3280.839895013123 ft; Label pitch including gap: 3.937007874015748 inch; Labels across: 1 units → 10,000.00 labels入力値に基づく計算です。仕様は仕入先に確認してください。
計算式をわかりやすく。
The result answers a specific purchasing question: Work out labels per roll with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read complete labels per roll in labels. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
この計算ツールの使い方
- 01
Collect Usable roll length (ft); Label pitch including gap (inch); Labels across (units). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review complete labels per roll and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
検算できる計算例
For this US purchasing example, enter usable roll length 3,280.84 ft, label pitch including gap 3.94 inch, labels across 1.00 units. The calculated complete labels per roll is 10,000.00 labels. The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- 有効ロール長さ
- 3,280.8399 ft
- 隙間込みのラベルピッチ
- 3.93700787 inch
- 幅方向のラベル列数
- 1 個
Labels = floor(Usable length(ft) × 12 ÷ Label pitch(in)) × Labels acrossよくある質問
Which units should I use for labels per roll?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two labels per roll results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record usable roll length (ft), label pitch including gap (inch), labels across (units) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
結果を使用する前に、表示された式、単位、前提条件を確認してください。
計算方法・単位・材料の前提条件 ↗