mils to GSM Calculator — US Units
mils to GSM connects the figures on a US supplier quote with the quantity used by your packaging operation. Have film thickness (mil), material density (g/cm³) ready before you start.
仕様を入力
代表的な密度です。実際の密度は樹脂グレードや配合によって異なります。入手できる場合は仕入先データや実測値を使用してください。
推定フィルム坪量
Estimated using typical PET / BOPET density of 1.39 g/cm³. Actual density varies by resin grade and formulation.
ラミネートは各材料層を個別に計算してください。紙に一般的な密度値を使用しないでください。
GSM = Thickness(mil) × 25.4 × Density(g/cm³)
Film thickness: 0.47244094488188976 mil; Material density: 1.39 g/cm³ → 16.68 g/m²入力値に基づく計算です。仕様は仕入先に確認してください。
計算式をわかりやすく。
The result answers a specific purchasing question: Work out mils to gsm with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read estimated film gsm in g/m². Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
この計算ツールの使い方
- 01
Collect Film thickness (mil); Material density (g/cm³). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review estimated film gsm and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
検算できる計算例
For this US purchasing example, enter film thickness 0.4724 mil, material density 1.39 g/cm³. The calculated estimated film gsm is 16.68 g/m². The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- フィルム厚さ
- 0.472440945 ミル
- 材料密度
- 1.39 g/cm³
GSM = Thickness(mil) × 25.4 × Density(g/cm³)よくある質問
Which units should I use for mils to gsm?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two mils to gsm results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record film thickness (mil), material density (g/cm³) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
結果を使用する前に、表示された式、単位、前提条件を確認してください。
計算方法・単位・材料の前提条件 ↗