Linear feet per lb Calculator — US Units
Linear feet per lb connects the figures on a US supplier quote with the quantity used by your packaging operation. Have web width (inch), film gsm (g/m²) ready before you start.
Your specifications
Use actual supplier or measured GSM when available.
Linear feet per lb
Linear ft/lb = 4,882.427636 ÷ (Width(in) ÷ 12 × GSM)
Web width: 31.496062992125985 inch; Film GSM: 80 g/m² → 23.25 ft/lbCalculated from your inputs. Confirm specifications with your supplier.
The formula, made clear.
The result answers a specific purchasing question: Work out linear feet per lb with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read linear feet per lb in ft/lb. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
How to use this calculator
- 01
Collect Web width (inch); Film GSM (g/m²). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review linear feet per lb and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
A calculation you can check
For this US purchasing example, enter web width 31.50 inch, film gsm 80.00 g/m². The calculated linear feet per lb is 23.25 ft/lb. The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- Web width
- 31.496063 inch
- Film GSM
- 80 g/m²
Linear ft/lb = 4,882.427636 ÷ (Width(in) ÷ 12 × GSM)Frequently asked questions
Which units should I use for linear feet per lb?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two linear feet per lb results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record web width (inch), film gsm (g/m²) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
Check the displayed formula, units and assumptions before using the result.
Method, units and material assumptions ↗