TOOL 19 / 136

mils to GSM Calculator — US Units

mils to GSM connects the figures on a US supplier quote with the quantity used by your packaging operation. Have film thickness (mil), material density (g/cm³) ready before you start.

Your specifications

g/cm³

Typical density. Actual density varies by resin grade and formulation; use supplier or measured data when available.

Results update as you edit. Nothing is saved until you choose to.
Live calculation

Estimated film GSM

16.68 g/m²
Estimated film yield292.71 ft²/lb

Estimated using typical PET / BOPET density of 1.39 g/cm³. Actual density varies by resin grade and formulation.

For a laminate, calculate each material layer separately. Do not use a generic density for paper.

GSM = Thickness(mil) × 25.4 × Density(g/cm³)

Film thickness: 0.47244094488188976 mil; Material density: 1.39 g/cm³ → 16.68 g/m²

Calculated from your inputs. Confirm specifications with your supplier.

The formula, made clear.

GSM = Thickness(mil) × 25.4 × Density(g/cm³)

The result answers a specific purchasing question: Work out mils to gsm with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read estimated film gsm in g/m². Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.

How to use this calculator

  1. 01

    Collect Film thickness (mil); Material density (g/cm³). Leave optional unknown values blank rather than substituting zero.

  2. 02

    Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.

  3. 03

    Review estimated film gsm and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.

A calculation you can check

For this US purchasing example, enter film thickness 0.4724 mil, material density 1.39 g/cm³. The calculated estimated film gsm is 16.68 g/m². The table lists the remaining inputs and results so the scenario can be checked or reproduced.

Film thickness
0.472440945 mil
Material density
1.39 g/cm³
GSM = Thickness(mil) × 25.4 × Density(g/cm³)
Estimated film GSM16.68 g/m²

Frequently asked questions

Which units should I use for mils to gsm?

Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.

Can I compare two mils to gsm results directly?

Yes, when both runs use the same specification, purchasing boundary and included charges. Record film thickness (mil), material density (g/cm³) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.

Check the displayed formula, units and assumptions before using the result.

Method, units and material assumptions ↗