TOOL 95 / 136

Thermoforming Scrap Rate Calculator — US Units

Thermoforming Scrap Rate connects the figures on a US supplier quote with the quantity used by your packaging operation. Have gross sheet input weight (lb), actual good part weight (lb), good parts produced (units) ready before you start.

Your specifications

units
Results update as you edit. Nothing is saved until you choose to.
Live calculation

Gross-input scrap rate

20.00 %
Material outside good output220.46 lb
Good finished output weight881.85 lb
Process material yield80.00 %

Measure input and good output over the same production boundary. This calculation does not distinguish trim, rejects, startup losses or recovered regrind.

Scrap rate = (Gross input − Good part weight × Good quantity) ÷ Gross input × 100%

Gross sheet input weight: 1102.3113109243877 lb; Actual good part weight: 0.044092452436975516 lb; Good parts produced: 20000 units → 20.00 %

Calculated from your inputs. Confirm specifications with your supplier.

The formula, made clear.

Scrap rate = (Gross input − Good part weight × Good quantity) ÷ Gross input × 100%

The result answers a specific purchasing question: Work out thermoforming scrap rate with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read gross-input scrap rate in %. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.

How to use this calculator

  1. 01

    Collect Gross sheet input weight (lb); Actual good part weight (lb); Good parts produced (units). Leave optional unknown values blank rather than substituting zero.

  2. 02

    Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.

  3. 03

    Review gross-input scrap rate and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.

A calculation you can check

For this US purchasing example, enter gross sheet input weight 1,102.31 lb, actual good part weight 0.0441 lb, good parts produced 20,000.00 units. The calculated gross-input scrap rate is 20.00 %. The table lists the remaining inputs and results so the scenario can be checked or reproduced.

Gross sheet input weight
1,102.31131 lb
Actual good part weight
0.0440924524 lb
Good parts produced
20,000 units
Scrap rate = (Gross input − Good part weight × Good quantity) ÷ Gross input × 100%
Gross-input scrap rate20.00 %

Frequently asked questions

Which units should I use for thermoforming scrap rate?

Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.

Can I compare two thermoforming scrap rate results directly?

Yes, when both runs use the same specification, purchasing boundary and included charges. Record gross sheet input weight (lb), actual good part weight (lb), good parts produced (units) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.

Check the displayed formula, units and assumptions before using the result.

Method, units and material assumptions ↗