mils to GSM Calculator — US Units
mils to GSM connects the figures on a US supplier quote with the quantity used by your packaging operation. Have film thickness (mil), material density (g/cm³) ready before you start.
您的规格参数
典型密度。实际密度随树脂牌号和配方而变化;如有供应商数据或实测数据,请优先使用。
估算薄膜克重
Estimated using typical PET / BOPET density of 1.39 g/cm³. Actual density varies by resin grade and formulation.
复合材料应逐层单独计算。纸张不应使用通用密度值。
GSM = Thickness(mil) × 25.4 × Density(g/cm³)
Film thickness: 0.47244094488188976 mil; Material density: 1.39 g/cm³ → 16.68 g/m²根据您输入的数据计算。请与供应商确认规格。
公式解释。
The result answers a specific purchasing question: Work out mils to gsm with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read estimated film gsm in g/m². Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
如何使用此计算器
- 01
Collect Film thickness (mil); Material density (g/cm³). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review estimated film gsm and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
可以核验的计算
For this US purchasing example, enter film thickness 0.4724 mil, material density 1.39 g/cm³. The calculated estimated film gsm is 16.68 g/m². The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- 薄膜厚度
- 0.472440945 密耳
- 材料密度
- 1.39 g/cm³
GSM = Thickness(mil) × 25.4 × Density(g/cm³)常见问题
Which units should I use for mils to gsm?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two mils to gsm results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record film thickness (mil), material density (g/cm³) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
使用结果前,请核对显示的公式、单位和假设。
方法、单位和材料假设 ↗