Nested Tray Stack Height Calculator — US Units
Nested Tray Stack Height connects the figures on a US supplier quote with the quantity used by your packaging operation. Have first tray height (inch), additional nesting pitch (inch), trays in stack (units) ready before you start.
您的规格参数
估算套叠高度
使用输入的套叠增量步距。实际压缩、零件公差和套叠表现可能不同;此计算不确定安全堆叠载荷。
堆垛高度 = 首件高度 +(数量 − 1)× 套叠增量
First tray height: 1.968503937007874 inch; Additional nesting pitch: 0.31496062992125984 inch; Trays in stack: 100 units → 33.15 inch根据您输入的数据计算。请与供应商确认规格。
公式解释。
The result answers a specific purchasing question: Work out nested tray stack height with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read estimated nested stack height in inch. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
如何使用此计算器
- 01
Collect First tray height (inch); Additional nesting pitch (inch); Trays in stack (units). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review estimated nested stack height and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
可以核验的计算
For this US purchasing example, enter first tray height 1.97 inch, additional nesting pitch 0.3150 inch, trays in stack 100.00 units. The calculated estimated nested stack height is 33.15 inch. The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- 首只托盘高度
- 1.96850394 inch
- 额外嵌套节距
- 0.31496063 inch
- 堆叠托盘数量
- 100 件
Stack height = First item height + (Quantity − 1) × Nesting pitch常见问题
Which units should I use for nested tray stack height?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two nested tray stack height results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record first tray height (inch), additional nesting pitch (inch), trays in stack (units) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
使用结果前,请核对显示的公式、单位和假设。
方法、单位和材料假设 ↗