Units per linear foot Calculator — US Units
Units per linear foot connects the figures on a US supplier quote with the quantity used by your packaging operation. Have print / pack repeat (inch), lanes across the web (lanes) ready before you start.
仕様を入力
Units per linear foot
工程ロス控除前の公称数量です。リピートには各生産単位の機械方向ピッチを含みます。
Units/linear ft = Lanes × 12 ÷ Repeat(in); Required ft = Target units ÷ Units/linear ft
Print / pack repeat: 9.84251968503937 inch; Lanes across the web: 2 lanes → 2.44 units/ft入力値に基づく計算です。仕様は仕入先に確認してください。
計算式をわかりやすく。
The result answers a specific purchasing question: Work out units per linear foot with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read units per linear foot in units/ft. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
この計算ツールの使い方
- 01
Collect Print / pack repeat (inch); Lanes across the web (lanes). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review units per linear foot and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
検算できる計算例
For this US purchasing example, enter print / pack repeat 9.84 inch, lanes across the web 2.00 lanes. The calculated units per linear foot is 2.44 units/ft. The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- 印刷・包装のリピート長
- 9.84251969 inch
- 幅方向の列数
- 2 lanes
Units/linear ft = Lanes × 12 ÷ Repeat(in); Required ft = Target units ÷ Units/linear ftよくある質問
Which units should I use for units per linear foot?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two units per linear foot results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record print / pack repeat (inch), lanes across the web (lanes) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
結果を使用する前に、表示された式、単位、前提条件を確認してください。
計算方法・単位・材料の前提条件 ↗