Adhesive Consumption Calculator — US Units
Adhesive Consumption connects the figures on a US supplier quote with the quantity used by your packaging operation. Have film area (ft²), dry adhesive coat weight (g/m²), adhesive solids (%) ready before you start.
您的规格参数
所需湿胶量
固含量按质量计。此值为扣除涂布、混胶或清洗损耗前的理论消耗量。
Dry lb = Area(ft²) × Dry GSM × 0.0002048161436; Wet lb = Dry lb ÷ Solids fraction
Film area: 10763.910416709721 ft²; Dry adhesive coat weight: 2 g/m²; Adhesive solids: 40 % → 11.02 lb根据您输入的数据计算。请与供应商确认规格。
公式解释。
The result answers a specific purchasing question: Work out adhesive consumption with US purchasing units. Enter the actual specification and compare the result on a consistent order basis. Read wet adhesive required in lb. Width and repeat measurements describe the actual purchased web or blank; a finished pack dimension is only interchangeable when the layout really uses that dimension. Keep input prices on the unit printed next to each price field. The US view converts the physical quantity and its price denominator together, so changing units preserves the calculated material or order value.
如何使用此计算器
- 01
Collect Film area (ft²); Dry adhesive coat weight (g/m²); Adhesive solids (%). Leave optional unknown values blank rather than substituting zero.
- 02
Use inches for short dimensions, feet for running length, square feet for coverage and pounds for mass. A US short ton is exactly 2,000 lb; US gallons are not Imperial gallons.
- 03
Review wet adhesive required and the secondary outputs. Check the quote boundary, then repeat with the competing specification or order quantity.
可以核验的计算
For this US purchasing example, enter film area 10,763.91 ft², dry adhesive coat weight 2.00 g/m², adhesive solids 40.00 %. The calculated wet adhesive required is 11.02 lb. The table lists the remaining inputs and results so the scenario can be checked or reproduced.
- 薄膜面积
- 10,763.9104 ft²
- 干胶涂布量
- 2 g/m²
- 胶黏剂固含量
- 40 %
Dry lb = Area(ft²) × Dry GSM × 0.0002048161436; Wet lb = Dry lb ÷ Solids fraction常见问题
Which units should I use for adhesive consumption?
Use the units shown beside each input. Coverage is in ft², mass is in lb and short dimensions are in inches. GSM and g/cm³ remain explicit technical material properties. The matching Metric edition is linked above the calculator.
Can I compare two adhesive consumption results directly?
Yes, when both runs use the same specification, purchasing boundary and included charges. Record film area (ft²), dry adhesive coat weight (g/m²), adhesive solids (%) for each run, then investigate any physical or commercial difference instead of treating the lower number alone as a supplier decision.
使用结果前,请核对显示的公式、单位和假设。
方法、单位和材料假设 ↗